November 17, 2026

FAA Halts Router Installations After Network Disruption

The Federal Aviation Administration (FAA) has temporarily stopped the installation of new routers across its national telecommunications network. This decision follows a technical issue that led to a nationwide ground stop on Friday, causing widespread flight cancellations and delays. The pause will remain until the FAA completes its investigation into the events of Friday.

According to reports confirmed by FOX Business and first shared by The Wall Street Journal, the issue occurred at an Arkansas radio transmitter site. The contractor, L3Harris, installed a new router that began sending excessive connection signals. This overwhelmed the network, disrupting communication between air traffic controllers and aircraft, and led to the ground stop directive.

The FAA identified problematic routers in Arkansas and Texas and took steps to isolate these components to stabilize the air traffic system. An additional measure included disabling the broadcasting capability of over 60 similar routers, which was suspected to have caused the disruption.

As part of efforts to modernize its communications infrastructure, the FAA aims to replace outdated copper wiring with fiber optic technology. This project is intended to improve the reliability of the system. L3Harris has pledged support for the FAA’s investigation to determine the specific conditions that resulted in the ground stop on November 13.

Transportation Secretary Sean Duffy addressed the situation in press conferences over the weekend. The ground stop led to the cancellation of about 12,462 flights, with 9,082 cancellations by major airlines, although not all were directly linked to the ground stop incident.

L3Harris and its telecommunications partners have reportedly completed over 70% of the transition from copper to fiber optic cables. This modernization effort remains crucial for enhancing the dependability of airspace communication systems.

TAGS: